With SystemsPulse installed, my starter will engage normally on the ground with accessory power off. In the air, it won’t work. #
The starter should not work if the accessory gearbox doesn’t work. The air behavior is correct, ground is not. We are investigating this.
I set my engine on fire, but I cannot put it out using the tablet. #
To put out the fire, you need to cut fuel flow to the engine so that it is extinguished. Then you can reset your engine using the tablet.
I am selecting the GTN/GTNXi option on the tablet, I see it change there, but the cockpit layout doesn’t change. #
This is a bug with the tablet. The panel layout will only change if the GTN is detected to be installed, but the tablet switches regardless. The good thing is that the aircraft will remember the choice and next time you run it with a GTN installed it will begin in that state.
With the release version, the fuel pressure is not displayed correctly in MSFS 2024. #
Known issue under investigation, currently pressure will only be displayed with the Fuel Pump on.
The plane cannot maintain a straight course in HDG mode in MSFS 2024. #
Known issue. Navigation mode currently works normally.
Dirt does not accumulate even with the option turned on. #
This happens randomly from user to user, and it may stop happening randomly as well. We’re working to fix this in the next update.
Autopilot does not move the Yoke #
Known issue and after investigation it will be fixed in the next update.
It is not possible to load passengers and fuel even with the plane stopped. #
We’ve learned that if the wind where the user is located is too strong, could end up moving the plane, even slightly. This will be fixed in the next update when the parameters are changed.
